My timing belt wasnt installed right on my 94 black saab and it bent some valves. Does someone know what it might cost to replace those valves???

Cheaper to buy recon engine..
Are you sure it is just the valves .because if the timing belt goes ,so dose valves .pistons the head .and others ..

it is probably not worth it. l had a 91' 9000 that happened to, it was a non turbo. l had a guy install a low mile turbo motor for two grand. it was like a new car, worth every penny. look for a motor swap. there a dime a dozen good luck

l am assuming u own a V6 SAAB, as this is the only engine SAAB used a belt on in 1994.

l just recently quoted two jobs on V6 SAAB's. Parts r hard to quote due to the fact there r 24 valves & u do not know ho many r bent. l would automatically assume half to being bent.

Valves run around $71 per exhaust valve & $54 per intake valve

Head gasket set around $300.

Labor including installation of valves around 13-17 hours

Used engines run between $1800-$2700

Not cheap in any way. V6 SAAB engines r very expensive.